System features
1、32—65536 Gray level，Support software Gamma correction。
2、Support the rules and special-shaped handle.
3、can support 2048 pixels。
4、Off-line(SD Card) control, play back content stored in the SD card.
5、store a maximum of 16 programs，copy multiple files to the SD card in order,
after formatting the SD card as “FAT” format.
6、The program must be named in orders . just as ：00_1.led, 01_1.led, 02_1.led.
7、It can use many sets to connect without reset. IC compatible with single and double line, if want to control the lamps with single IC, no need to connect the CLK wire. Support chips
TM-1803,1804,1809,1812，1829、1903、1904、1912
UCS-1903、1903B 、1909、2903,2909,2912,1912
WS-2811、2801、2803
SM-16711、16716、16726
P9813、6803 etc。 Product advantage
1. It can use single one or many sets to connect to realize synchronization.
2. One output port，at most to load 1024/2048 pixels.
3. There are test programs in the controller,can test it without SD card.Buttom “SET”is used to choose the chip type and save the file.
4. When the chip for LED is single line chip just with data, then just need to be connected with DAT and GND of the controller. If the chip for LED is double line chip with DAT and CLK, then need to be connected with DAT, CLK, and GND of the controller.
5. If you need to use RS485 signal you need to connect controller A interface with LED lamps A, controller B interface with LED lamps B.
6. If the work voltage of the controller same as the lamps,they can connect to the same power supply,otherwise,must use two different power supplies.
7. When make program in the LedEdit software, select control model like this: T – 1000S-CHIP TYPE.
K series controller
